|
Puts the autoloader into single step mode. This is useful for troubleshooting problems or closely examining the pick cycle. The autoloader has the ability to single-step through all of it’s pick/fetch/load/unload/eject routines by setting al ass (autoloader single-step) to 1. When this feature is enabled you must now type ale step to continue to the next step rather than hit any key as before. This will allow you to better diagnose the state of the machine during each autoloader step by allowing you to enter diagnostic commands between steps.
The autoloader will now single-step through the bay-load and configure-picker routines as well when al ass is set to 1.
|