Description:

Displays the status of the chiller or controls the chiller unit if connected.

The 'chiller' command displays the current status of the chiller unit in a single caption. Other chiller commands control the functions of the chiller unit. Turn the chiller on using the pump command which will start to circulate the chiller fluid. No chilling actually takes place until a 'chiller on' command is issued turning on the compressor.

Notes:

The cable check done is the same as for the debris removal unit since the two units are daisy chained.

Applies To:

• ThermoFlex
• Trendsetter_400/800_Auto

Syntax:

See Also:

• Command: chiller on
• Command: chiller off
• Command: chiller pump on
• Command: chiller pump off
• Command: act chiller
• Command: act chpump
• Command: dr