Description:

Performs various commands on the proofing contact cleaning roller (CR). Command options are:

cr - Displays the status of the CR sensors.

cr drum - Moves the CR up to the drum.

cr vr - Moves the CR up to the vacuum roller.

cr home - Moves the CR to it's "home" position where it's safely away from the drum and not in contact with the vacuum roller.

cr tilt <dir> - Moves the CR tilt cylinder in the specified direction. Optional directions are "up" (towards the drum), "down" (away from the drum), and "idle" (no air pressure in either direction).

cr main <dir> - Moves the CR tilt cylinder in the specified direction. Optional directions are "up", "down", and "idle" (no air pressure in either direction).

Applies To:

• Trendsetter_400/800_Proofing

Syntax:

Notes:

See Also: