Description:

Allows various development-type diagnostic commands to be performed directly to the TEE satellite board registers, such as reading or writing directly from or to a specific register.

If no parameters are specified, the contents of all the registers on the TEE-board are dumped to the display.

Here are the different optional ways to enter the command:

sat - This will dump the contents of all registers on the TEE-board to the display.

sat <reg#> - This will dump the specified register's contents to the display.

sat <reg#> <hex value> - This will write the given hexidecimal value to the specified register address.

sat <reg#> n <bit#> - This will display the state of the specified bit at the given register address.

sat <reg#> n <bit#> 0|1 - This will write a 0 or 1 to the specified bit address.

Applies To:

• Trendsetter_400/800
• Trendsetter_400/800_Auto
• Trendsetter_400/800_Proofing
• ThermoFlex

Syntax:

Notes:

CAUTION: This command is meant for really bizzarre diagnostics, typically only in engineering development, and should NEVER be performed without a register table and a schematic at close hand!

For base Trendsetter, this only applies to TEE-board equipped machines.

See Also:

• Command: spi
• Command: sat reset
• Command: sat adc
• Command: sat temp