Description:

Allows various development-type diagnostic commands to be performed directly to a satellite board or register, such as reading or writing directly from or to a specific satellite board register. When no parameters are given, a listing of the available boards and their addresses is shown.

CAUTION: All of these "sat" commands are meant for really bizzarre diagnostics, typically only in engineering development, and should NEVER be performed without a register table and a schematic at close hand!

Applies To:

• Trendsetter_VLF
• Platesetter_VLF

Syntax:

Notes:

See Also:

• Command: spi
• Command: sat reset
• Command: sat adc
• Command: sat temp