Description:

Writes or reads the specified value to or from the specified satellite board, register, and/or bit location.

If only the board number is specified, the contents of all the registers on that board are dumped to the display. Here are the different optional ways to enter the command:

sat <board#> --This will dump the contents of all registers on the specified board to the display.

sat <board#> <reg#> --This will dump the specified register's contents to the display.

sat <board#> <reg#> <hex value> --This will write the given hexidecimal value to the specified register and board address.

sat <board#> <reg#> n <bit#> --This will display the state of the specified bit at the given register & board address.

sat <board#> <reg#> n <bit#> 0|1 --This will write a 0 or 1 to the specified bit address.

Applies To:

• Trendsetter_VLF
• Platesetter_VLF

Syntax:

Notes:

See Also:

• Command: sat adc
• Command: sat temp
• Command: engine