Description:

Sets the scorr value for all pixel pairs in the stroke.

scorr init

Sets the scorr value for all pixel pairs in the stroke to 0.0.

scorr init <value>

Sets the scorr value for all pixel pairs in the stroke to the value specified by <value>.

scorr init <value> <slope>

Sets the scorr value for all pixel pairs in the stroke to the triangular pattern specified by <value> and <slope>.

The <value> parameter specifies the scorr value. The units for scorr values are percent and can be negative or positive.

The <slope> parameter specifies the slope for the triangular pattern. The initial scorr value is determined by <value>. Each successive scorr value is adjusted by the slope multiplied by the stroke increment. When the resulting scorr value is not within the range +1.27 to -1.28, the slope is inverted. The stroke increment is fixed at two (hard-wired by the LVD board).

Applies To:

• Thermal

Syntax:

Notes:

See Also:

• Command: scorr