Description:

This sets the state variables which are stored in nvs, for details see nvs STATE subsystems listed under notes below.

To display or modify the state parameters, the state option is used. Other than the slight change in syntax, this command works exactly as the other set commands do. State parameters are not divided into calibration and configuration categories.

Note: State parameters should be modified only by qualified Creo personnel.

Applies To:

• All

Syntax:

Notes:

The subsystems are Bay, Plate_loc, Sys, General, Flags, Bstats, Mstats, and Imaging.

Bay and Plate_loc require an index, nl the bay number or the plate location (machine specific). Others may also require index (under construction).

See Also:

• Command: set
• Use the index and look under "state"