Long Name:

Applies to:

Description:

Disables the checking of the sensors on the Table_Tilt_Cylinder. The sensors indicate cylinder extended and cylinder retracted. When nts=1 then the firmware will not check the position of the cylinder after causing it to move.

• This parameter also works the same way for the Table_Stow_Cylinder.

Disables the checking of the sensors on the Table_Stow_Cylinder. The sensors indicate cylinder extended and cylinder retracted. When nts=1 then the firmware will not check the position of the cylinder after causing it to move.

• nts=0 indicates sensor is installed
• nts=1 indicates No sensor

Type:

Default:

• 0

Range:

• 0 to 1

Notes:

Table_Tilt_Cylinder tilts the table for load and unload.

Table_Stow_Cylinder together with Table_Tilt_Cylinder tilts the table to the eject position for feeding the plate into the conveyer.

If sensor disabled (nts=1), Firmware defaults to using time delay instead of waiting for the cylinder extended (or retracted) sensor to become true.

timer: in milliseconds set by SET ALDLY TTILT. When the sensor is enabled a timeout error if generated is the cylinder extended (or retracted) sensor does not become true with in a certain time. The same value is used for timeout when sensor is enabled.

Partition:

See Also: