Long Name:

Applies to:

Description:

The parameter should be set equal to the distance between the surface of the registration pins (when the LE clamps are open) and the tripping point of the table plate sensor (when the table is up). This value is used to help the firmware measure the plate size while loading.

The plate size is calculated by seeing how far the drum moved before the table plate sensor became uncovered, then adding this distance to the sensor_to_lec parameter.

To calibrate the parameter simply get a decent sized plate (msz between 600 and 1,100 mm) and load it with the command "load <msz> cal". For more information on what this does, see the "load" command.

Type:

Default:

• 509

Range:

• 0 to 1000 mm

Notes:

When you automatically calibrate this parameter with the "load <msz> cal" command the value will be slightly larger than the distance between the reg. pins and the table plate sensor. This is to take into account the inherent latency delays of reading the table plate sensor inputs, firmware calculations, etc.

Partition:

See Also: