Long Name:

Applies to:

Description:

Sets the minimum allowable vacuum pressure level for the firmware to believe that a plate is being held by the table vacuum. When the measured vacuum pressure is below this parameter, the firmware will not believe that a plate is on the load/unload table. The vacuum is only checked at the beginning of the load cycle, before the table is lifted up.

Type:

Default:

• 200

Range:

• 0 to 1024 (no units)

Notes:

Typically there should be no need to adjust this parameter, as there is plenty of difference in the vacuum level between when there is and isn't a plate covering the vacuum holes.

Partition:

See Also: