Long Name: | tec_on_drum |
Applies to: |
|
Description: |
This state parameter is used to keep track of where the trailing edge clamps are. If this parameter is set to 1, the firmware thinks the clamps are on the drum. This parameter is used by the firmware for internal 'housekeeping'. It is not normally modified with the 'set' command. |
Type: | integer |
Default: |
|
Range: |
|
Notes: |
Partition: | state |
See Also: |
Go to CTP Firmware NVS Parameter Index Page
Go to CTP Firmware NVS Parameter Search Page