NVS Parameter: aldrv sds

Long Name:

 step_direction_sense

Applies to:
  • ThermoFlex

    • Description:

    The step_direction_sense parameter is used to control the active logic level for the stepper driver direction signal. The correct value for this parameter (0 or 1) will depend on the configuration and wiring of the stepper motor drive amplifier and motor.

    Type:

    		 byte

    Default:
    • 1

    Range:
    • 0 to 254

    ArraySize:

    		 2

    Partition:

    		 cfg

    See Also:

    Go to CTP Firmware NVS Parameter Index Page

    Go to CTP Firmware NVS Parameter Search Page

    Go to CTP Firmware Main Page

    Creo CTP F/W NVS Parameter Documentation / ctp_firmware@creo.com / Updated: Tue May 14 20:03:21 2002 PST