|
The step_enable_sense parameter is used to control the active logic level for
the stepper driver enable signal. The correct value for this parameter (0 or 1)
will depend on the configuration of the stepper motor drive amplifier.
For stepper motor amplifiers that use an active LOW enable signal, set this
parameter to 0.
For stepper motor amplifiers that use an active HIGH enable signal, set this
parameter to 0.
Syntax: set aldrv 2 ses
Other products have more than one stepper motors axis, so used "set aldrv 1" and
"set aldrv 2" for the separate axes. The 3244 Trendsetter Autoloader has only one
axis, but kept the same parameter structure for consistency.
|