NVS Parameter: alproof vsi

Long Name:

 vac_sensors_installed

Applies to:
  • Trendsetter_400/800_Proofing

    • Description:

    Indicates if the proofing vacuum sensors are installed or not.

    Set to 0 to bypass the vacuum sensors.

    Set to 1 to enable the vacuum sensors.

    Type:

    		 byte

    Default:
    • 1

    Range:
    • 0 to 1 (no units)

    Notes:

    This is a separate parameter to allow production and engineering tests to exercise the loader without using any media.

    Partition:

    		 cfg

    See Also:

    Go to CTP Firmware NVS Parameter Index Page

    Go to CTP Firmware NVS Parameter Search Page

    Go to CTP Firmware Main Page

    Creo CTP F/W NVS Parameter Documentation / ctp_firmware@creo.com / Updated: Tue May 14 20:03:25 2002 PST