Long Name:

Applies to:

Description:

The worst-case time in seconds that it takes for a command sequence to complete. This parameter is used by the firmware to determine when to give up waiting for complex command sequences such as loading and unloading to complete. There should be no need to change this parameter from its default value under normal circumstances. It should be changed only after consultation with the firmware group.

Type:

Default:

• 300 seconds

Range:

• 0 to 800 seconds

Notes:

This parameter must be entered in whole seconds, no decimal is allowed. This parameter must be greater than the sum of table_move_up + user_timeout + the actual load time.

Partition:

See Also: