NVS Parameter: carriage again

Long Name:

 driver_accel_gain

Applies to:
  • All

    • Description:

    Carriage stepper motor current when accelerating while moving to position and while plotting. Normally, this parameter should not be changed from the factory default. Maximum current is 254. Setting this current too low may lead to the carriage stalling while moving.

    Type:

    		 integer

    Default:
    • 254

    Range:
    • 0 to 254

    Notes:

    Partition:

    		 cal

    See Also:
  • NVS: carriage mgain
  • NVS: carriage hgain
  • NVS: carriage pgain

    • Go to CTP Firmware NVS Parameter Index Page

    Go to CTP Firmware NVS Parameter Search Page

    Go to CTP Firmware Main Page

    Creo CTP F/W NVS Parameter Documentation / ctp_firmware@creo.com / Updated: Tue May 14 20:03:29 2002 PST