NVS Parameter: carriage mspeed

Long Name:

 max_speed

Applies to:
  • All

    • Description:

    The maximum carriage speed when it is moving to position (i.e. not plotting). Normally, this parameter should not be changed from the factory default. If set too high, the carriage will stall. If set too low, overall image time may become unacceptable.

    Type:

    		 integer

    Default:
    • 2500 (Platesetter_3244)
    • 2200 (Trendsetter_NEWS)
    • 1500 (Trendsetter_400/800)
    • 1000 (Platesetter_VLF, Trendsetter_VLF)

    Range:
    • 0 to 5000 [mil/sec]

    Notes:

    The maximum speed attainable is a function of the following accel, period, and kspeed parameters.

    Partition:

    		 cfg

    See Also:
  • NVS: carriage accel
  • NVS: carriage period
  • NVS: carriage kspeed

    • Go to CTP Firmware NVS Parameter Index Page

    Go to CTP Firmware NVS Parameter Search Page

    Go to CTP Firmware Main Page

    Creo CTP F/W NVS Parameter Documentation / ctp_firmware@creo.com / Updated: Tue May 14 20:03:30 2002 PST