Long Name:

Applies to:

Description:

This parameter rotates the image on the plate to compensate for the position of the plate registration pins. This parameter is calibrated during factory integration and normally should not change after this. Adjustments should be made with advice from factory integrators.

A positive rotation angle will rotate the image in a counter-clockwise direction.

This parameter specifies the rotation for the home-side broadsheet plate. This is the plate on the right when looking at the Trendsetter from the front.

Only plates smaller than 450mm will use these two pins.

Type:

Default:

• -1000

Range:

• -32767 to 32767 [microrads]

Notes:

When loading the plate onto the drum, the plate is not aligned in the center. The plate is positioned so that its center line is 221mm to the right of the device center line.

Partition:

See Also: