Long Name:

Applies to:

Description:

This parameter rotates the image on the plate to compensate for the position of the plate registration pins. This parameter is calibrated during factory integration and normally should not change after this. Adjustments should be made with advice from factory integrators.

A positive rotation angle will rotate the image in a counter-clockwise direction.

For plates that are smaller than 560mm, the 4th registration pin in used and the very_small_plate_rotate gc parameter is used instead of the plate_rotate gc parameter.

Type:

Default:

• -900

Range:

• -32767 to 32767 [microrads]

Notes:

When loading the plate onto the drum, the plate is not aligned in the center. The plate is positioned 209mm from the center line of a 32" plate and the center line of a 22" plate.

Partition:

See Also: