Long Name:

Applies to:

Description:

Enables (1) or disables (0) edge detection for this mode. If set to 0, imaging will start at the approximate plate edge. Disabling edge detection will make the registration between multiple plates poor.

Works with mode edge parameter. If mode edge is set to 0, edge detection is disabled.

As of NVS module V2.16 (July, 2001), setting this parameter to 2 means that the firmware will accept a "double edge" (i.e., head 'sees' two edges while scanning the plate)

Type:

Default:

• 1

Range:

• 0 to 2

Notes:

Partition:

See Also: