NVS Parameter: state plate_loc ssz

Long Name:

 sscan_size

Applies to:
  • All

    • Description:

    This state parameter is not normally modified with the 'set' command. The firmware uses this parameter for internal 'housekeeping'.

    Plate size in the carriage travel direction, copied from state bay ssz when the plate was picked.

    Type:

    		 integer

    Default:
    • 0

    Range:
    • 0 to 1200 [mm] (Platesetter_3244, Trendsetter_400/800)
    • 762 to 2032 [mm] (Platesetter_VLF, Trendsetter_VLF)

    Notes:

    Partition:

    		 state

    See Also:

    Go to CTP Firmware NVS Parameter Index Page

    Go to CTP Firmware NVS Parameter Search Page

    Go to CTP Firmware Main Page

    Creo CTP F/W NVS Parameter Documentation / ctp_firmware@creo.com / Updated: Tue May 14 20:03:49 2002 PST