Long Name:

Applies to:

Description:

This is the minimum system pressure in PSI that will reliably run the pneumatic actuators in the CTP machine. If the system pressure falls below this value plate loading and imaging can not proceed.

Type:

Default:

• 70 PSI

Range:

• 0 to 100 PSI

Notes:

This parameter became neccessary when Trendsetters were shipped with new "Trendsetter Engine Electronics" (TEE) boards. These boards replaced two previous boards (LUE and TIF boards) which read a single digitial value from the pressure system regulator to determine good pressure. The TEE board in newer Trendsetters contains a pressure transducer which reads the system pressure as an analog value. The sys_pressure_thresh parameter is used to compare for acceptable system pressure.

This parameter will appear if older Trendsetters (contaning LUE and TIF boards) have their firmware upgraded but will have no function or effect in those machines.

Partition:

See Also: