SATELLITE BOARD BOOT CODE Release Notes:
----------------------------------------

SAT Boot v1.03 15-Oct-1999 LWIL
-------------------------------

- Fixed QSPI setup for the GENINE board. Now supports GENINE Rev B boards.
- Now supports the new 'generic' 68376 BBR code module instead of the
  previous assembler BBR stub.
- Built against Baseline 1401.
- Uses SMN (Small Monitor) Subsystem v1.05
- The BMM Rom binary image (Satbmm.Bin) uses the generic 68376 BBR code
  version 1.00.

SAT Boot v1.02 06-Aug-1999 LWIL\RHIN
------------------------------------

- Added support for PDB Rev. 'B' hardware board.
- Added support for GENINE I/O board.
- This boot code has only been tested on PDB Rev. 'A', and ALICE boards. The
  PDB Rev. 'B' and GENINE boards do not yet exist.
- Does not yet drive the CAN bus.

SAT Boot v1.01 07-Jun-1999 LWIL
-------------------------------

- Removed hard-coded boardtype setting to ALICE. Should now work/detect
 the PDB board.
- Does not yet drive the CAN bus.

SAT Boot v1.00 04-May-1999 LWIL
-------------------------------

- The first 'real' version of the SAT boot code for both ALICE and PDB
  boards. Not yet tested, as the h/w does not yet exist.
- Does not yet drive the CAN bus.
- Does NOT run on the ICE boards at all.
  
SAT Boot v1.01 13-Apr-1999 LWIL
-------------------------------

- Fixed timeout problem in binary download. Now times out after 10 seconds.
  Note that the very first download character still has no timeout on it.
- Changed binary download code, to not erase the flash sector containing the 
  FW Directory untill after a successfull download has completed. This fixes
  problems when a binary download is aborted, and the FW DIR table is left
  empty.
- Only runs on ICE boards, Rev 'A' and 'Rev 'B'.
  
SAT Boot v1.00 05-Mar-99 LWIL
-----------------------------

- First version of Satellite Boot code, only runs on ICE boards,
  Rev 'A' and 'Rev 'B'.
- Does not yet drive the CAN bus.