focus cal [ < cal mode > ] Commands to calibrate the focus laser. Used for integration. "focus cal" should never be run except on media of known reflectivity (Kodak IR plate at sr 0.16). The purpose is of this command is to setup the head dependent focus parameters. Media dependent changes belong in the media NVS settings. On other media use "focus cal reflect" to determine a suitable value for the "media sr" setting. This last variant of this command is the only one that should need to be used in the field. To use this command switch to new media setting with "mode media" command position head in front of media loaded on drum and then issue the command "focus cal reflect". It is possible to do all the calibrations done by "focus cal" one by one using the commands "focus cal fshift", "focus cal fhead", "focus cal fmod" and "focus cal error". These commands adjust the head parameters "fshift", "fheadcal", "fmodcal" and "ferrcal" respectively. Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 This command is available. Field 27-Jun-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:24:42 2008 PST