laser < laser mode > Controls the laser by communicating with the HC board. laser on Turns on the laser. If the "head lsrmode" is set to 0 or 3 (original mode) then the power setpoint is the value specified by the hdm NVS parameter "wpower" or "wpowern" depending on the mode of operation (wide or narrow). When not running a work station image then selection of wide or narrow depends on the setting of "hdp fnm". Starting with head version 1.56 (needs matching MPE code as well) if the "head lsrmode" is set to 1 or 2 (exposure control mode) then the laser power setpoint is the hdm NVS parameter "wpowere". Note that this value is automatically set everytime a machine initiated stroke cal is done. The calculated wpowere value depends on the "media sens" setting, the "drum diam", the "hdm ds" setting and the "head swidth" setting. Note that the new exposure mode does not use the obsolete "sys es" flag. Instead, it is controlled instead by the "head lsrmode" parameter. Beam positioning is enabled. Used for field service and integration. laser idle Turns on the laser (to idle). The power setpoint is hardcoded to 1W. Beam positioning is enabled. Used for field service and integration. laser standby Turns on the laser (to standby). The power setpoint is the value specified by the hdm NVS parameter "wpowers". Beam positioning is enabled. Used for field service and integration. laser off Turns off the laser. On 40W heads also closes the relay to turn on the head. It is often necessary to issue a "laser off" command to get the head to turn on after a reset. Beam positioning switches to hold mode, i.e., the current in the beam position actuator is kept constant. Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 This command is available. Field 27-Jun-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:24:53 2008 PST