34033 Parameter PRM: Cannot modify parameter, not in configuration mode Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The parameter of interest is a configuration parameter. A configuration parameter can only be modified when the PRM subsystem is in the configuration mode. Note that a configuration parameter normally should not be changed because the machine may suffer SERIOUS damage if the parameter is set incorrectly. Ensure that you understand what you are doing before configuring this type of parameters. You should not be getting this error under normal operation. If you are trying to fix a machine, call Creo Service for further assistance. This error is reported. PRM subsystem is not in configuration mode and an attempt to modify a configuration parameter was detected. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:00 2008 PST