34313 Data Path Control DPC: timed out waiting for stripe to complete Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 The test pattern generator (TPG) on the DNE or MCE is not functioning properly. The TPG is used at the beginning and end of every image to setup and shutdown the data buffers. If this error occurs at the beginning of an image, the DNE or MCE's power supply levels should be checked using the test points on board. If the problem does not go away, the DNE or MCE should be replaced. If this error occurs at the end of an image, the DNE or MCE should be checked. However, the error may be due to a firmware bug in the image shutdown routine, and the responsible firmware programmer should be contacted. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Out of spec. power supply levels Faulty DNE or MCE. If at the end of an image, possibly due to a firmware bug. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:02 2008 PST