34331 Data Path Control DPC: orthog slope smaller than minimum, check plate rotation Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 The rotation needed to correct for the registration pin placements is too small (large negative value). Check that the gc rotation parameters are at their factory settings (refer to the configuration record). If they are, and this error is still reported, a firmware bug may be responsible. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Rotation of plate is too large in the negative direction. 21-Jul-2003 Updated description to more accurately reflect the description and cause of the error. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:03 2008 PST