34908 Routing Layer RTL: NT COM port or pipe conflict Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Do not enter the same com port for two communication link for the NT version of firmware. For example, do not specify COM1 for the link between DNE and ICE1 and the link between DNE and the workstation. If problem persists, contact the responsible firmware developer at Creo. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. There is COM port or pipe name conflict. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:04 2008 PST