35756 Product Support PRD: Drum is spinning when a stationary drum is expected Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 An operation requiring a stationary drum has been attempted but drum motion has been detected. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. A media loading procedures requiring a stationary drum has failed due to the detection of drum motion. An attempt has been made to enable the drum tach encoder simulator while the drum is spinning. If the drum is spinning it is probably under realtime servo control (unless it is idling and coasting to a stop). In any event, tach encoder simulation may not be attempted unless the drum is stopped. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:05 2008 PST