36808 Firmware Health HLT: BCM comm. between DNE and ICE has stopped Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Check the connection of the optical fiber connecting the TX of the ICE and the RX of the DNE. Ensure that it is plugged in tightly. If the problem doesn't go away, check the condition of the optical fiber between the DNE and the ICE. Try replacing the cable if the condition of the cable is bad. If problem persists, contact the responsible firmware developer at Creo. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. The DNE detected the presence of a cable between the DNE and the ICE; however, BCM communication between the two device is not possible. 08-JAN-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:07 2008 PST