40039 Stepper Motor Control SMC: Failed to detect the cable [<Name of the stepper motor>] Gravure Japanese_Newspaper_OEM_Engine Magnus_VLF Thermoflex Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The remote board was unable to perform the requested command because the controller failed to detect the presence of the stepper cable. This error only applies the onboard stepper driver (Stepper 1 on a GENINE Board). A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Hardware problem. Name of the stepper motor. 08-May-2003 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:22 2008 PST