40413 Media Handler MDH: Picker wrist sensor is not working Trendsetter_400/800 Trendsetter_400/800_Autoloader Trendsetter_NEWS Trendsetter_Series_4 If this error is reported, the picker wrist sensor is probably faulty. After moving the picker up and in, but before moving the wrist in, the picker wrist sensor is checked. If it reads low, then this error is reported. The sensor can be checked with the <<picker>> command. The sensor name is "AL_SensorPickerWristOut". It is possible to bypass this sensor temporarily with the "scan" command. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. The sensor may not be close enough to the metal strip on the right side of the picker. The wiring may be faulty, or intermittant. The picker head may not have moved in (sensor only reads true if head in and wrist out). 18-DEC-2001 Created. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:26 2008 PST