43027 Debris Removal DEB: No debris removal options are enabled on this device Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Thermoflex Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Some or all of the hardware required to enable debris removal is missing. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Cause 1: Debris removal not configured in software. Solution: The debris blower installed flag is not set. Configure the system for debris removal. For MPE check "SET SYS DBIN" is 1 for POC and 2 for PACC. For MCE check that OPTION DEBRIS UDRCL ENABLE is enabled. For Lotem Control Software check the registry entries: ..\LOTEM400V\MACHINE\UDRC Installed (set to 2 for UDRC-L) ..\LOTEM400V\IO OBJECTS\DISTRIBUTION\SOLENOIDS SWITCH\Debris Removal\Open (set to 1) Also check the nozzle sensor installed parameter: MPE / MCE: set debris nsi (or nozzle sensor installed) = 1 Lotem Control Software: UDRC Registry check nozzle sensor = 1. 07-Jul-2001 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:36 2008 PST