43303 Carriage (CTP) CRG: Carriage is reserved, command ignored Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The carriage was in the process of executing a command when it received a new command that does not have permission to preempt the current command. If the new command was issued from the diagnostic monitor it is only necessary to wait until the existing command completes and try again. If this error occurs during normal operation it indicates a probable firmware error. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Firmware bug or diagnostic/service shell command conflicting with a previous carriage command. 08-Jun-2001 Automated conversion to new FW1 error template. ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:37 2008 PST