43808 Z Axis Control ZAC: Media not found by Z axis, confirm dimensions Gravure Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS The z axis has complete several jogs after arriving within focus range but is still unable to get within range with the focus laser. Double Check size of loaded Drum/Cylinder and accompanying media. This error is reported. Incorrect Drum/Cylinder Diameter, Wrong media thickness and/or incorrect media reflectivity settings are all possible causes. This error can also occur if the "zac BaseFocusDist" parameter is not set correctly. 25 Jul 2001 ../prm/zac_zac_BaseFocusDist.xmlPRM: zac BaseFocusDist ../commands/zdrive_focus.xmlCommand: zdrive focus ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:38 2008 PST