44206 Head Communication Driver DTL: Timeout attempting to close communication port Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Firmware timed out while closing the head communication port A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error was obsoleted at version 1.21 of the DTL subsystem where changes were made to remove semaphore protection around closing the head communication port. The only thing that could cause a port close time out is the inability to obtain a semaphore. Now that the semaphore protections is gone the error can not occur. Fault error in firmware. 27-Feb-2002 ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:39 2008 PST