44951 Exposure Head Interface EHI: DTD laser diode over current Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 Current is more than 120% of the "head nomlsrcur" value. Either the setpoint power ("hdm wpower(x)") is too high or else the laser has reached the end of its life. Check servo setpoint (wpower(x), head lsrmode, and hdp fnm A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Current is more than 120% of the "head nomlsrcur" value. 03-Jul-2002 ../prm/ehi_head_nomlsrcur.xmlPRM: head nomlsrcur ../prm/ehi_head_lsrmode.xmlPRM: head lsrmode ../prm/ehi_hdm_wpower.xmlPRM: hdm wpower ../prm/ehi_hdm_wpowern.xmlPRM: hdm wpowern ../prm/ehi_hdm_wpowere.xmlPRM: hdm wpowere ../prm/ehi_hdm_wpowers.xmlPRM: hdm wpowers ../prm/ehi_hdp_fnm.xmlPRM: hdp fnm ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:42 2008 PST