44980 Exposure Head Interface EHI: LV Too much stray light for beam balance Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The amount of leakage light on the shutter sensor is so large that the HC board can not null it out. Check contrast with "head power full / head power off" to determine if LV is working. If contrast is bad it may be possible to improve it by changing the "head bposn" setting. A device error has occurred: You may be able to continue by pressing the "resume" button onscreen (if present) or by resetting the device and workstation. For support under your service contract, contact the Creo Response Center at 1-(800) 472-2727 or online at http:\\eCentral.creo.com (or your local service representative) To speed troubleshooting, please make a note of error numbers, the media type/size and any information about the workflow or job that might be relevant. This error is reported. Too much leakage light detected on shutter sensor. 03-Jul-2002 ../prm/ehi_head_bposn.xmlPRM: head bposn ../commands/head_power.xmlCommand: head power ..\..\ShowAllErrors.htmFirmware 1 Error Index ..\..\ShowAllCommands.htmFirmware 1 Command Index ..\..\ShowAllParameters.htmFirmware 1 Parameter Index Updated: Thu Jul 17 07:23:42 2008 PST