EHI head diag0 Gravure Japanese_Newspaper_OEM_Engine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 The first four bits specify the signal sent to pin 1 of the HC board test point cable accessed via the PD board. Setting Signal 0 focus error 1 lens positioning servo error 2 write laser power servo error 3 beam positioning servo error The second four bits specify data stored to the lower half of the second bank when diag5 > 0. Note that in order to store focus data, diag1 must be set to 0 as well. Storing Data 0 focus data (stored in swaths) 16 write laser (M2) sensor 32 BP0 sensor 48 BP1 sensor 64 nosepiece sensor 80 diode temperature 96 ambient temperature 112 case temperature 128 humidity 144 LV temperature 160 focus sum 176 focus difference 192 diagnostic port 0 output 208 diagnostic port 1 output 224 focus lens position This parameter is available.

Please issue the appropriate monitor command to determine this parameter's default value.

Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.

07-May-2002 Normal

..\..\ShowAllErrors.htmFirmware 1 Error Index

..\..\ShowAllCommands.htmFirmware 1 Command Index

..\..\ShowAllParameters.htmFirmware 1 Parameter Index

Updated: Thu Jul 17 07:23:57 2008 PST