MDH
mandrel arborselmindiam
Thermoflex
This parameter along with ArborSelMaxDiam describes the region of overlap of job sizes that
can go on either the small or large arbor. Any diameter that falls between
ArborSelMinDiam and ArborSelMaxDiam will result in an operator prompt during loading
that will ask the operator to choose either the small or large arbor. Note
that there is no tolerance associated with this value so if a tolerance is required.
Therefore, please set the parameter appropriately. A value of 1000um is probably a
good value as long as it doesn't overlap with the next job size.
Think of this as the smallest repeat that will fit on the large arbor.
This parameter is available.
0 [microns]
0 to 340000 [microns]
7 Feb 2005
None
..\..\ShowAllErrors.htmFirmware 1 Error Index
..\..\ShowAllCommands.htmFirmware 1 Command Index
..\..\ShowAllParameters.htmFirmware 1 Parameter Index