MPC focus basethickness Gravure Japanese_Newspaper_OEM_Engine Lotem_400_Fiber_Head_Machine Lotem_800_Fiber_Head_Machine Lotem_Quantum Magnus_400 Magnus_800 Magnus_VLF Slave_MCE_Firmware Thermoflex Think_Motion_Controller Trendsetter_400/800 Trendsetter_NEWS Trendsetter_Series_4 This parameter is provided to allow the firmware to detect when double-picking occurs, that is, two or more plates sandwiched together. It is recommended that this parameter be chosen as the largest media thickness that will be used at the target site. It does not necessarily have to be the thickness of the media used to install the head. However, the following constraint must be satisfied: (Base thickness) - (Install thickness) = (Error head is installed to) For example, if the thickest media will be 305 microns, then set the base thickness parameter to this value. If the plate used to install the head is 215 microns thick, then you must ensure that the head is installed to an error of +90 microns. Using this method will ensure that all media thickness required for the site will be supported by the head, in addition to ensuring that adequate bump tracking can be performed by the head. This parameter is available.

0 [microns]

Please issue the appropriate monitor command to determine this parameter's minimum and maximum values.

01-Mar-2004 This parameter MUST not be set to any value other than zero for devices that have a Z-stage. Furthermore, if there is no danger of double-picking plates, then this parameter does not have to be used. This parameter applies to TH2 heads only. Normal

..\..\ShowAllErrors.htmFirmware 1 Error Index

..\..\ShowAllCommands.htmFirmware 1 Command Index

..\..\ShowAllParameters.htmFirmware 1 Parameter Index

Updated: Thu Jul 17 07:24:04 2008 PST