|
|
|
|
Display directory information for each file in the firmware bundle. The following information is displayed:
|
|
| <Type> <Version> <Offset> <Length> <Checksum> <Status>
|
|
| The file type is one of the following:
|
|
|
|
|
| The code file is loaded by the flash boot loader during initialization while the appropriate Xilinx file is loaded by the firmware during initialization.
|
|
| The interpretation of the file version depends on the file type. The file version of the code file isn't implemented and the file version of the Xilinx file corresponds to the hardware version.
|
|
| The file offset and file length can be used to read the file from flash. Note that the file offset is the offset within the firmware directory section ( the firmware directory section is located at the start of flash ).
|
|
| The file checksum is used to verify the file when it is read from flash and determines the file status. The status of the file will be one of the following:
|
|
|
|
|
| If the calculated file checksum matches the directory file checksum, then the file status is "Pass". Otherwise the file status is "Fail".
|
|
| This is intended as a development tool and should not be used during normal operation.
|
Thermal 1.0 / 1.7x equivalents:
|
|
|
- The monitor command dir list does not have an equivalent.
|
COMMAND: fls read <address> <length>
|