|
|
|
|
The diode on-time could not be logged for the last plot. Most likely, this was caused by an error reading or writing parameters.
|
|
| There are various causes for this error. The failure occurred in a different part of the firmware, therefore this error is the translation of a lower-level error. If you need to find out which lower-level error is the cause, enable verbose level 2 for the DOT module, and error translations will be printed to the screen.
|
To track down the error, enable verbose level 2 for the DOT module, and repeat the operation.
|
- The firmware could not log the on-time for the last plot.
|
COMMAND: vbs enable (<subsystem>|all) <level>
|