Tfx Errorcode
[00908] Requested power is too low

Service Information The power is too low to lookup on the power curve. You cannot request extrapolation below the lowest curve point. The power curve points should be set up so the lowest point is at the lowest usable power.

You may request extrapolation above the highest curve point.

Operator Action None.

Causes
  • Attempt to set a power lower than supported by the power curves.

Related Documents COMMAND: dpc points [<power_points>]

Applies to: TFX
Modified: Wed Aug 15 17:04:20 2001
Updated: Thu Jul 17 02:31:28 2008
Module: DPC