|
|
|
|
| address
| Specifies the first address to read from. (Byte offset, word aligned)
|
|
| length
| Specifies the number of values to read. (Byte length, word aligned).
|
Read word(s) from the flash. Addresse and legth are in bytes but must be word aligned. Therfore only even addresses and lengths are valid.
|
|
| For Head Controller versions 1.0- there are two flash sections. The main section is 4Mx8. Therfore valid addresses for this command are even numbers from 0h to 3FFFFEh. The extended section is 32Mx8. Therfore valid addresses for this command are even numbers from 0h to 1FFFFFEh.
|
|
| For Head Controller versions 2.0+ there is one flash section. This main section is 32Mx8. Therfore valid addresses for this command are even numbers from 0h to 1FFFFFEh.
|
|
| This is intended as a development tool and should not be used during normal operation.
|
Thermal 1.0 / 1.7x equivalents:
|
|
|
- The monitor command fls read (main|extended) <address> <length> does not have an equivalent.
|
|
| Thermal 2 equivalents:
|
|
|
- The monitor command fls read (main|extended) <address> <value> is comparable to fls read <address> <value>.
|
COMMAND: fls erase (main|extended) <address> <length>
|
|
|
COMMAND: fls write (main|extended) <address> <value>
|