Description:

scorr

Displays the current scorr values as an array of numbers. The number in the upper-left corner corresponds to the first pixel pair in the stroke and the number in the lower-right corner corresponds to the last pixel pair in the stroke.

scorr <sample>

Displays the scorr value associated with the pixel pair identified by <sample>.

scorr <sample> <value>

Sets the scorr value associated with the pixel pair identified by <sample> to the value specified by <value>.

The <sample> parameter specifies the pixel pair. The sample number ranges from 0 to one less than the number of pixels per stroke divided by the stroke increment. The number of pixels per stroke is determined by the mode NVS parameter "pixels_per_stroke" while the stroke increment is fixed at two (hard-wired by the LVD board).

The <value> parameter specifies the scorr value. The units for scorr values are percent and can be negative or positive.

Applies To:

• Thermal

Syntax:

Notes:

See Also:

• Command: scorr init
• Command: scorr save