Description:

This command can be used to move the head stage to a specific position at a specified speed. You must enter a destination either in motor steps or in microns, if you use microns then you must follow the value with " um" or it will be treated as steps. After specifying a destination you may optionally specify a speed, either SLOW, MED, or FAST. These speeds are setup in the "aldrv #" nvs subsystem. The ThermoFlex uses aldrv 1.

Notes:

None.

Applies To:

• ThermoFlex

Syntax:

See Also:

• Command: stage
• Command: stage stop
• Command: stage init
• Command: stage install
• Command: stage getfocus
• Command: stage zero
• Command: stage home