Error Message:

MISC: NVS modified and saved, but not backed up!

Applies to:

• All

Service Information:

Whenever an NVS parameter is saved, this message will be reported at regular intervals until either a "nvs dump [diff [cal|cfg] [min]]" or "fsave all" command is issued. This message is intended to encourage operators/service people to have an up-to-date copy of NVS memory always on hand. Note that this message will not be reported if NVS parameters have only been modified but not saved.

Backup NVS memory to disk, preferably using the "nvs dump [diff [min]]" command.

Operator Action:

This message does not indicate a problem with the recorder. However inform Creo service of the message when convenient.

Cause:

• An NVS parameter has been saved since last NVS backup.

See Also: